Viking Johnson UltraGrip

The UltraGrip range now meets Australian standards, from DN40-DN600 in PN16 and PN10 Working Pressures.

• Captive, non-rotating bolts across the whole range require a single spanner to install.
• Gasket/gripper are fully contained in the end ring housing, ensuring the product slides easily over pipes.
• Bolt orientation in couplings/reducing couplings can be reversed to suit
  site conditions.

• Progressive gripping technology: with increasing end load restraint capability as the internal pressure in the pipe increases.
• Uses grit and friction to mobilise end restraint forces ensuring the pipe surface is not damaged.
• One gripper system suits all recommended pipe materials.
• Gripper has large footprint, reducing the load on the pipe surface.

• Patented Gasket Technology incorporates a waffle profile design, providing localised high pressure points on the pipe surface.
• EPDM (water quality approved) and Nitrile gaskets variants.

• Accommodates high tolerance on pipe outside diameter – up to 54mm.
• Interlocking “spring” and retention tab ensures gasket and grippers retract into and are retained in the housing of the end ring during transit.

As standard, the flange adaptors are multi-drilled to accommodate BS EN 1092-1 PN10 & 16.